Thank you for participating in our HP Community. When the website support page opens, Select (as available) a Category > Topic > Subtopic NOTE: Content depends on device type and Operating SystemĬategories: Alerts, Warranty Check, HP Drivers / Software and BIOS, How-to Videos, Bulletins/Notices, How-to Documents, Troubleshooting, User Guides / Manuals, Service and Maintenance Guide (Replacement Parts and Procedures), Product Information (Specifications), more Reference and Resources – Places to find help, solve problems, and learn about your Device Optional > Switch ON the fast startup setting The south bridge will grab the cycle, and since it's not directed at an internal. Try shutting down the notebook from Windows key > Power Since the address is not memory or AGP, it forwards it to Hublink bus.Boot the computer > Log in > Wait around for a couple of minutes (yes, wait, do not rush) >.Wait for the computer to shut down completely (a few seconds).When the command window opens, type / paste the following command and hit Enter: Windows key + X + A (opens Cmd prompt as Admin) Double-click on the Require use of fast startup setting. Navigate to Computer Configuration -> Administrative Templates -> System -> Shutdown. Type in gpedit.msc and hit the Enter key. (or use vi instead of nano) and set the GRUBDEFAULT to the value you counted. Follow these steps to enable fast start-up in Windows 11 from Group Policy Editor. Then edit the default that grub will boot: sudo nano /etc/default/grub. IF it does, count the menuentries starting from 0. and see if it has UEFI Firmware Settings. Remove Check (clear box) Turn on fast startup (recommended) >Ĭlose programs (browsers, games, email, etc) and close any open windows Run: grep -e 'menuentry ' /boot/grub/grub.cfg. Settings > System > Power and Sleep > Additional Power Settings >Ĭlick Change settings that are currently unavailable > Power on, immediately tap-tap-tap F10 to enter the BIOS Turn on or restart the computer, quickly press ESC, and then press f10 NOTE: "Advanced" section is available in business / commercial class computers and workstations You can disable the Fast Boot Option here. ![]() That will get you into the BIOS setup Utility. If you have Fast Boot enabled and you want to get into the BIOS setup. Question is referring to Bios > Boot Options Fast Boot can be enabled or disabled in the BIOS setup, or in HW Setup under Windows.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |